Specified Technologies, Inc.
200 Evans Way
Emergency: 1-800-255-3924
| Ingredient Name |
Cas Number |
Percent |
| Calcium Carbonate |
1317-65-3 |
30-40 |
| Titanium Dioxide |
13463-67-7 |
2-6 |
| Phthalate Esters |
85-68-7 |
4-6 |
***********EMERGENCY OVERVIEW***********
* Possible Skin and Eye Irritant. Red Solid. *
***********************************************************
Potential Health Effects:
EYE: Contact my cause irritation
SKIN: Contact may cause irritation
INGESTION: Relatively non-toxic.
INHALATION: Irritation of the nose, throat, and lungs may result from over-exposure to vapors or mist
CHRONIC (CANCER) INFORMATION: Phthalate esters classified by EPA as possible human carcinogen
LONG TERM TOXIC EFFECTS: None known.
INHALATION: Remove to fresh Air
SKIN CONTACT: Wash thoroughly
EYE CONTACT: Irrigate eyes with running water for at least 15 minutes. Get medical attention if irritation develops
INGESTION: None applicable
FLASH POINT > 93 deg. C
EXTINGUISHING MEDIA: Dry Chemical; Carbon Dioxide; Foam; Water spray for large fires
SPECIAL FIRE FIGHTING PROCEDURES: As for surrounding fire
Safeguards (Personnel)
NOTE: Review FIRE FIGHTING MEASURES and HANDLING (PERSONNEL) sections before proceeding with clean-up. Use appropriate PERSONAL PROTECTIVE EQUIPMENT during clean-up.
Store under ambient conditions. No special handling required. Avoid excessive heat and freezing.
EYE PROTECTION REQUIREMENTS: Safety glasses/goggles
SKIN PROTECTION REQUIREMENTS: Gloves. Barrier skin cream
RESPIRATOR REQUIREMENTS: None
VENTILATION REQUIREMENTS: If needed, use local exhaust ventilation to keep airborne concentrations below the TLV.
Exposure Guidelines:
Exposure Limits:
PEL(OSHA) Particulates (not Otherwise Classified) 15 mg/m3, 8 hr. TWA, total dust 5 mg/m3, 8 hr. TWA, dust
TLV(ACGIH) None Established
PHYSICAL FORM: Smooth paste, slight ammonia odor
SPECIFIC GRAVITY: 1.2-1.5
PERCENT VOLATILES: 17-20
EVAPORATION RATE: (either = 1): Slower
BOILING POINT: 100-105 deg. C
SOLUBILITY IN WATER: Dissolves wet, insoluble when cured
PH: 8.0-8.5
STABILITY: This is a stable material
CONDITIONS TO AVOID: Excessive heat and freezing
HAZARDOUS POLYMERIZATION: Will not occur
INCOMPATIBILITIES: None special
Mixture not tested by based on components:
May be irritating to skin and eyes. As a precautionary measure, preclude from those individuals with a history of respiratory ailments.
E{A Integrated Risk Information System (IRIS): Butyl benzyl phthalate, CAS# 85-68-7, carcinogen assessment is: C (possible human carcinogen)
Non data.
Waste Disposal: Treatment, storage, transportation, and disposal must be in accordance with applicable Federal, State/Provincial, and Local regulations
DOT - not regulated
U.S. Federal Regulations
TSCA Inventory Status: Article
Section 313 Supplier Notifications.
This product contains no toxic chemicals subject to the reporting requirements of Section 313 of the Emergency Planning and Community Right-To-Know Act of 1986 and of 40 CFR 372.
NPCA-HMIS Rating
- Health: 1
- Flammability: 2
- Reactivity: 0
Personal Protection rating to be supplied by user depending on use conditions.
STATE RIGHT-TO-KNOW LAWSNo substances on the state hazardous substances list, for the states indicated below, are used in the manufacture of products on this Material Safety Data Sheet, with the exceptions indicated. While we do not specifically analyze these products, or the raw materials used in their manufacture, for substances on various state hazardous substances lists, to the best of our knowledge the products on this Material Safety Data Sheet contain no such substances except for those specifically listed below:
SUBSTANCES ON THE NEW JERSEY WORKPLACE HAZARDOUS SUBSTANCE LIST PRESENT AT A CONCENTRATION OF 1% OR MORE (0.1% FOR SUBSTANCES IDENTIFIED AS CARCINOGENS, MUTAGENS OR TERATOGENS): NJTSRN-SSP WARNING: SUBSTANCES KNOWN TO THE STATE OF CALIFORNIA TO CAUSE CANCER: Possible traces of formaldehyde and acrylonitrile.
WARNING: SUBSTANCES KNOWN TO THE STATE OF CALIFORNIA TO CAUSE BIRTH DEFECTS OR OTHER REPRODUCTIVE
HARM: None known.
This information relates to the specific material designated and may not be valid for such material used in combination with any other materials or in any process. Such information is to the best of our knowledge and belief accurate and reliable as of the data compiled. However, no representation, warranty, or guarantee is made as to its accuracy, reliability or completeness. It is the user's responsibility to satisfy himself as to the suitability and completeness of such information for his own particular use. We do not accept liability for any loss or damage that may occur form the use of this information.