Install Directions for PolyPhon™ Acoustical Panels
Acoustical wall panels may be attached to walls with a variety of hardware:
Z-Clips
If the wall panels are designed to be removable, the use of Z-clips and/or Zbars may be used for installation.
- Z-clips are factory installed on the back of the panels and z-bar, or additional zclips are sent in a shipping package to be installed on the wall where the panels are to be installed.
Step 1:
- Determine the Z-clip or Z-bar locations on the wall to line up with the Z-clip locations on the wall panels. (This "top" of this location is calculated by adding the "z-clip location on panel" to the distance from the top of the wall to the top of the panel.)
- Secure the Z-clip or Z-bar and washers to the wall with 2 screws. (Place 1 washer between the wall and Z-clip or Z-bar at each screw location).
- Slide the Z-clips on the panels onto the Z-clips or Z-bars on the wall.
|
Lay out the panel locations. Determine z-clip or z-bar location on wall to line up with z-clip location on panels. |
 |
Impaling Pin
- Mount Pins to the wall surface by removing the paper backing and pressing the pin's flat backing FIRMLY ONTO WALL.
- Pins should be located on the wall to avoid the fabric on the back of the panel
- Apply a golf-ball size amount of panel adhesive on the wall surface next to each pin
- Push the panel onto the pins using firm pressure with the palm of your hand in the area around each pin
| Number of Pins per Panel |
||
|
|
Panel Length | Number of Pins |
| Up to 24' | 4 | |
| 24' to 48' | 4-6 | |
| 48' to 72' | 6-8 | |
| 72' to 96' | 6-8 | |
| 96' to 120' | 10 | |
