Have a question and can't find the answer?

Have a question you couldn't find the answer to on any of our pages? Ask your question directly below:

AlphaSorb™ Barrier Fabric Wrapped Wall Panel Installation

| More

 

  • Due to the weight of Alphasorb™ barrier wall panels they are designed to run from floor to ceiling.
  • Impaling clips are shipped from the factory with the panels and should be screwed into the wall where the panels are to be installed. Care should be taken to screw the impaling clips into a stud when possible and to space the clips so that they will be evenly spaced on the back of the panel.

Note: Be sure to place the impaling clips so that they do not come into contact with the fabric on the back of the wall panel.

  • The back of the Alphasorb™ barrier wall panel should be covered with a construction adhesive and placed onto the wall in the desired location.
  • The impaling clips will hold the panel in place while the adhesive sets.